uploaded 3 months ago
The component provides a general purpose PPP connectivity, typically used as WiFi-PPP router

readme

# ESP PPP Link component (eppp_link)

The component provides a general purpose connectivity engine between two microcontrollers, one acting as PPP server (slave), the other one as PPP client (host).
This component could be used for extending network using physical serial connection. Applications could vary from providing PRC engine for multiprocessor solutions to serial connection to POSIX machine. This uses a standard PPP protocol to negotiate IP addresses and networking, so standard PPP toolset could be used, e.g. a `pppd` service on linux. Typical application is a WiFi connectivity provider for chips that do not have WiFi

## Typical application

Using this component we can construct a WiFi connectivity gateway on PPP channel. The below diagram depicts an application where
PPP server is running on a WiFi capable chip with NAPT module translating packets between WiFi and PPPoS interface.
We usually call this node a SLAVE microcontroller. The "HOST" microcontroller runs PPP client and connects only to the serial line,
brings in the WiFi connectivity from the "SLAVE" microcontroller.

```
             SLAVE micro                                  HOST micro
    \|/  +----------------+                           +----------------+
     |   |                |          serial line      |                |
     +---+ WiFi NAT PPPoS |=== UART / SPI / SDIO =====| PPPoS client   |
         |        (server)|                           |                |
         +----------------+                           +----------------+
```

## API

### Client

* `eppp_connect()` -- Simplified API. Provides the initialization, starts the task and blocks until we're connected

### Server

* `eppp_listen()` -- Simplified API. Provides the initialization, starts the task and blocks until the client connects

### Manual actions

* `eppp_init()` -- Initializes one endpoint (client/server).
* `eppp_deinit()` -- Destroys the endpoint
* `eppp_netif_start()` -- Starts the network, could be called after startup or whenever a connection is lost
* `eppp_netif_stop()` --  Stops the network
* `eppp_perform()` -- Perform one iteration of the PPP task (need to be called regularly in task-less configuration)

## Throughput

Tested with WiFi-NAPT example

### UART @ 3Mbauds

* TCP - 2Mbits/s
* UDP - 2Mbits/s

### SPI @ 16MHz

* TCP - 5Mbits/s
* UDP - 8Mbits/s

### SDIO

* TCP - 9Mbits/s
* UDP - 11Mbits/s

Links

Supports all targets

License: Apache-2.0

To add this component to your project, run:

idf.py add-dependency "espressif/eppp_link^0.2.0"

or download archive

Stats

  • Archive size
    Archive size: 27.85 KB
  • Downloaded in total
    Downloaded in total 1.0k times
  • Downloaded this version
    This version: 731 times

Badge

espressif/eppp_link version: 0.2.0
|