# Example for `aht` driver ## What it does It checks sensor calibration state and then shows temperature and humidity in loop. ## Wiring Connect `SCL` and `SDA` pins to the following pins with appropriate pull-up resistors. | Name | Description | Defaults | |------|-------------|----------| | `CONFIG_EXAMPLE_I2C_MASTER_SCL` | GPIO number for `SCL` | "5" for `esp8266`, "6" for `esp32c3`, "19" for `esp32`, `esp32s2`, and `esp32s3` | | `CONFIG_EXAMPLE_I2C_MASTER_SDA` | GPIO number for `SDA` | "4" for `esp8266`, "5" for `esp32c3`, "18" for `esp32`, `esp32s2`, and `esp32s3` | ## Notes - Choose I2C address under `Example configuration` in `menuconfig`. The default is `AHT_I2C_ADDRESS_GND` (`ADDR` pin is connected to GND). - Choose chip type under `Example configuration` in `menuconfig`. The default is `AHT_TYPE_AHT1x` (AHT10 or AHT15)
To create a project from this example, run:
idf.py create-project-from-example "esp-idf-lib/aht=1.0.5:default"