## 1.1.1 - When reading more bytes than fit in one RMT memory block on ESP32 and ESP32-S2, data will be read in chunks. ## 1.1.0 - Add UART backend support for 1-Wire bus (`onewire_new_bus_uart`) alongside the existing RMT backend. ## 1.0.4 - Support `en_pull_up` config option in `onewire_bus_config_t`, which can enable the internal pull-up resistor on the GPIO pin used for the one-wire bus. This is useful when using a GPIO pin that does not have a pull-up resistor connected externally. ## 1.0.3 - Improve the driver to support esp-idf v6.0 ## 1.0.2 - raise recovery time to support more sensor on longer wire (d0b2b52) ## 1.0.0 - Initial driver version, with the RMT driver as backend controller