HTTP2 TLS Abstraction Layer


# Abstraction layer for HTTP2 with TLS [![Component Registry](]( This component contains an abstraction layer which exposes simpler set of APIs combining `nghttp2` (HTTP/2 C Library) and `esp-tls` (from ESP-IDF) components.


## 1.0.5 - Added http2_request example in the component.

readme of http2_request example

# HTTP/2 Request Example Establish an HTTP/2 connection with - Performs a GET on /index.html ## How to use example Before project configuration and build, be sure to set the correct chip target using ` set-target <chip_name>`. ### Hardware Required * A development board with ESP32/ESP32-S2/ESP32-C3 SoC (e.g., ESP32-DevKitC, ESP-WROVER-KIT, etc.) * A USB cable for power supply and programming ### Configure the project ``` menuconfig ``` Open the project configuration menu (` menuconfig`) to configure Wi-Fi or Ethernet. See "Establishing Wi-Fi or Ethernet Connection" section in [examples/protocols/](../../ for more details. ### Build and Flash Build the project and flash it to the board, then run monitor tool to view serial output: ``` -p PORT flash monitor ``` (Replace PORT with the name of the serial port to use.) (To exit the serial monitor, type ``Ctrl-]``.) See the Getting Started Guide for full steps to configure and use ESP-IDF to build projects. ## Example Output ``` I (5609) example_connect: - IPv4 address: I (5609) example_connect: - IPv6 address: fe80:0000:0000:0000:ae67:b2ff:fe45:0194, type: ESP_IP6_ADDR_IS_LINK_LOCAL Connecting to server Connection done [get-response] <!DOCTYPE HTML> <html lang="en"> . . . Body of index.html . . . . </html> [get-response] Frame fully received [get-response] Stream Closed ```


Supports all targets

License: Apache-2.0

To add this component to your project, run: add-dependency "espressif/sh2lib^1.0.5"

or download archive


  • espressif/nghttp >=1.41.0
  • ESP-IDF >=5.0
  • Examples:


    more details


    • Downloaded in total
      Downloaded in total 131.5k times
    • Downloaded this version
      This version: 9.1k times


    espressif/sh2lib version: 1.0.5 |