example_04_power_modes

# Power modes
This example shows the possibility of VL53L7CX to change power mode. It initializes the VL53L7CX ULD, set a configuration, change the power mode, and starts a ranging to capture 10 frames.

## Get started
In order to run this example you need to increase the main stack size else you will get a stack overflow error.

Run `idf.py menuconfig`. Go to Component Config -> ESP System settings and increase the Main task stack size to at least `7168`.



## Hardware notes

Default I²C pins used by the converted examples:
- SDA: GPIO 21
- SCL: GPIO 22

Adjust in `main.c` if needed.