nicolaielectronics/esp-hosted-tanmatsu

19 examples

• host_bluedroid_ble_compatibility_test

  This example tests Bluetooth compatibility using the ESP32-P4 as a host connected to an ESP32 co-processor via SPI FD.

  12.51 KB
• host_bluedroid_bt_hid_mouse_device

  This example shows how to implement a Bluetooth HID mouse device using Classic Bluetooth APIs, enabling it to send reports to a remote host.

  10.70 KB
• host_bluedroid_host_only

  This is a Bluetooth Host using ESP-Hosted as HCI IO to the BT Controller.

  6.14 KB
• host_bt_controller_mac_addr

  This example shows how to change the MAC Address for the Bluedroid Beacon, allowing it to be identified by a BLE scanner.

  7.60 KB
• host_gpio_expander

  This example demonstrates how to use the ESP-Hosted solution to control the GPIOs of the slave (co-processor) from the host MCU.

  2.89 KB
• host_hosted_cp_meminfo

  This example enables a memory monitor on the co-processor to track heap usage and provides various reporting options.

  11.73 KB
• host_hosted_events

  This example uses ESP-Hosted events to manage connectivity with the co-processor, detecting resets or hangs.

  11.68 KB
• host_manage_copro_ext_coex

  This example demonstrates configuring and using External Coexistence (EXT_COEX) in the ESP-Hosted co-processor, allowing the host MCU to control the slave's PTA for managing 2.4 GHz ISM band access.

  4.17 KB
• host_network_split__power_save

  This example demonstrates using Network Split and Host Deep Sleep to maintain WiFi while saving power on the host MCU.

  17.68 KB
• host_nimble_bleprph_host_only_uart_hci

  This example demonstrates UART transport for BLE peripherals using ESP32 and custom configurations.

  501.02 KB
• host_nimble_bleprph_host_only_vhci

  This example demonstrates the Bluetooth Hosted HCI transport provided by ESP-Hosted on ESP32 microcontrollers.

  13.26 KB
• host_peer_data_transfer

  This example demonstrates how to send and receive raw binary data between a host device and a coprocessor, allowing maximum control over data format.

  5.72 KB
• host_performs_slave_ota

  This example demonstrates ESP-Hosted Transport OTA for updating slave firmware through an existing connection without additional hardware.

  36.98 KB
• host_sdcard_with_hosted

  This example demonstrates using an SD card on an ESP32-P4 dev board with ESP-Hosted communicating via SDIO.

  12.44 KB
• host_shuts_down_slave_to_power_save

  This example demonstrates host-side control of an ESP slave to reduce power consumption by shutting it down when idle.

  7.28 KB
• host_transport_config

  This example demonstrates how to configure ESP-Hosted transport interfaces (SDIO, SPI, UART) before initialization.

  6.63 KB
• host_wifi_easy_connect_dpp_enrollee

  This example shows how to configure ESP devices as an enrollee using Device Provisioning Protocol (DPP). DPP provides a simple and secure way to onboard ESP devices to a network.

  6.26 KB
• host_wifi_itwt

  This example shows how to use itwt of wifi, which works only in station mode and requires AP support.

  14.98 KB
• slave

  The ESP-Hosted MCU Slave Example demonstrates how slave firmware provides Wi-Fi and Bluetooth connectivity to host MCUs via ESP32 chips.

  159.85 KB