| Supported Targets | ESP32 | ESP32-C3 | ESP32-C5 | ESP32-C6 | ESP32-H2 | ESP32-P4 | ESP32-S2 | ESP32-S3 | | ----------------- | ----- | -------- | -------- | -------- | -------- | -------- | -------- | -------- | # DCC RMT Example This example shows how to set up a DCC RMT encoder to send packets using the RMT peripheral. After configuring the hardware, an idle packet is sent in an endless loop. ## How to Use Example ### Hardware Required * A development board with any supported Espressif SOC chip (see `Supported Targets` table above) * A USB cable for Power supply and programming The GPIO number used in this example can be changed according to your board, by the macro `RMT_GPIO_NUM` defined in the [source file](https://github.com/ZIMO-Elektronik/DCC/blob/master/examples/esp32/main/app_main.cpp). ### Build and Flash Run `idf.py -p PORT flash monitor` to build, flash and monitor the project. (To exit the serial monitor, type ``Ctrl-]``.) See the [Getting Started Guide](https://docs.espressif.com/projects/esp-idf/en/latest/get-started/index.html) for full steps to configure and use ESP-IDF to build projects.
To create a project from this example, run:
idf.py create-project-from-example "zimo-elektronik/dcc=0.38.0:esp32"