espressif/esp_hosted

17 examples

• host_bluedroid_ble_compatibility_test

  This example tests Bluetooth compatibility on mobile phones using the ESP32-P4 Dev Board as a BT Host, connected to an ESP32 co-processor via GPIO…

  12.51 KB
• host_bluedroid_bt_hid_mouse_device

  This example demonstrates how to implement a Bluetooth HID device using the Classic Bluetooth HID profile, simulating a Bluetooth HID mouse that…

  10.70 KB
• host_bluedroid_host_only

  This example demonstrates a Bluetooth Host using ESP-Hosted as HCI IO to the BT Controller. It is based on the modified bt_discovery example and…

  6.14 KB
• host_bt_controller_mac_addr

  This example demonstrates how to change the MAC address for a BLE device. When executed, a BLE scanner will identify a device labeled…

  7.47 KB
• host_gpio_expander

  This example demonstrates how to use the ESP-Hosted solution to control the GPIOs of a slave co-processor from the host MCU, enabling the host to…

  2.89 KB
• host_hosted_events

  This example demonstrates using ESP-Hosted events to detect resets or hangs of the co-processor, specifically with the ESP32-C6. It manages…

  11.69 KB
• host_network_split__power_save

  This example demonstrates the integration of Network Split and Host Deep Sleep features on ESP-Hosted systems, where the host MCU saves power by…

  17.68 KB
• host_nimble_bleprph_host_only_uart_hci

  This example demonstrates the use of a custom UART transport for an ESP32-P4 connected to another ESP32 over UART, with specific configuration steps…

  501.02 KB
• host_nimble_bleprph_host_only_vhci

  This example uses the Bluetooth Hosted HCI transport provided by ESP-Hosted, requiring the Bluetooth controller to be disabled and enabling the…

  13.26 KB
• host_peer_data_transfer

  This example demonstrates how to send and receive raw binary data between a host device and a coprocessor, allowing for maximum control over data…

  5.72 KB
• host_performs_slave_ota

  This example demonstrates ESP-Hosted Transport OTA, allowing firmware updates of a slave device through an existing ESP-Hosted connection…

  36.98 KB
• host_sdcard_with_hosted

  This example demonstrates how to use an SD card on an ESP32-P4 dev board with ESP-Hosted utilizing SDIO for communication with the ESP32-C6. It…

  12.44 KB
• host_shuts_down_slave_to_power_save

  This example demonstrates host-side control of an ESP slave to reduce power consumption by shutting it down when idle and waking it on demand. It…

  7.28 KB
• host_transport_config

  Demonstrates how to configure ESP-Hosted transport interfaces (SDIO, SPI, UART) before initialization, allowing customization of parameters like…

  6.63 KB
• host_wifi_easy_connect_dpp_enrollee

  This example shows how to configure ESP devices as an enrollee using the Device Provisioning Protocol (DPP), also known as Wi-Fi Easy Connect. DPP…

  6.26 KB
• host_wifi_itwt

  This example shows how to use itwt of wifi, which operates only in station mode and requires the AP to support it. Itwt functions under different…

  14.98 KB
• slave

  The ESP-Hosted MCU Slave Example demonstrates firmware that enables host MCUs to access Wi-Fi and Bluetooth capabilities of ESP32 series chips via…

  467.42 KB