espressif/esp_hosted

17 examples

• host_bluedroid_ble_compatibility_test

  This example tests Bluetooth compatibility with mobile phones, modified to work with ESP-Hosted. It runs on the ESP32-P4 Dev Board as a BT Host,…

  12.51 KB
• host_bluedroid_bt_hid_mouse_device

  This example demonstrates how to implement a Bluetooth HID device using the Classic Bluetooth HID profile APIs. It simulates a Bluetooth HID mouse…

  10.70 KB
• host_bluedroid_host_only

  This example demonstrates a Bluetooth Host using ESP-Hosted as HCI IO to the BT Controller, modified from the bt_discovery example. It requires…

  6.14 KB
• host_bt_controller_mac_addr

  This example demonstrates how to change the MAC Address of the Bluetooth Controller. When executed, a BLE Scanner will identify a device named…

  7.47 KB
• host_gpio_expander

  This example demonstrates how to use the ESP-Hosted solution to control the GPIOs of the slave (co-processor) from the host MCU, enabling the host to…

  2.89 KB
• host_hosted_events

  This example demonstrates the use of ESP-Hosted events to detect co-processor resets or hangs, allowing the host to reinitialize ESP-Hosted for…

  11.69 KB
• host_network_split__power_save

  This example demonstrates the integration of **Network Split** and **Host Deep Sleep** in ESP-Hosted systems, allowing a host MCU to minimize power…

  17.68 KB
• host_nimble_bleprph_host_only_uart_hci

  This example demonstrates a BLE Peripheral using a custom UART transport. It includes instructions on disabling the default UART transport,…

  501.02 KB
• host_nimble_bleprph_host_only_vhci

  This example showcases the Bluetooth Hosted HCI transport using ESP-Hosted, where the Bluetooth controller is disabled and the default UART transport…

  13.26 KB
• host_peer_data_transfer

  This example demonstrates how to send and receive raw binary data between a host device and a coprocessor, allowing for maximum control over the data…

  5.72 KB
• host_performs_slave_ota

  This example demonstrates ESP-Hosted Transport OTA, allowing slave firmware updates through an existing ESP-Hosted connection (SDIO/SPI/UART) without…

  36.98 KB
• host_sdcard_with_hosted

  This example demonstrates how to use an SD card with an ESP32-P4 dev board and ESP-Hosted communication through SDIO. It initializes the SDMMC…

  12.44 KB
• host_shuts_down_slave_to_power_save

  This example demonstrates host-side control of an ESP slave to reduce power consumption by shutting the slave down when idle and waking it up on…

  7.28 KB
• host_transport_config

  This example demonstrates how to configure ESP-Hosted transport interfaces (SDIO, SPI, UART) before initialization, covering default transport…

  6.63 KB
• host_wifi_easy_connect_dpp_enrollee

  This example demonstrates how to configure ESP devices as an enrollee using the Device Provisioning Protocol (DPP), also known as Wi-Fi Easy Connect.…

  6.26 KB
• host_wifi_itwt

  This example shows how to use itwt of wifi, which only works in station mode and requires the AP to support it. Itwt functions under different power…

  14.98 KB
• slave

  The ESP-Hosted MCU Slave Example demonstrates slave firmware that allows host MCUs to utilize Wi-Fi and Bluetooth through ESP32 series co-processors…

  467.42 KB